True Ribbon Transducer
Features
High-pressure injection molded 5mm faceplate.
Pure Aluminum ribbon.
Super strong Neodymium magnet for high efficiency.
Built-in Impedance conversion transformer.
Effective from 1,700 Hz upwards due to the large diaphragm area and low self-resonance.
Extremely thin diaphragm (0.009mm Aluminum foil) guarantees a high degree of signal fidelityand broad frequency response.
Low distortion factor, good power-handling capabilities, highly linear impedance and amplitudfrequency response and the broad frequency response range.
Flat impedance curve from 1,000Hz to 40KHz.
Specifications
Ribbon material
Aluminum
Ribbon mass
11mg
Ribbon dimension
8mm x 60mm x 0.009mm
Ribbon area
480mm x 480mm
Gap flux
0.6 Tesla
Gap height
3mm
Impedance
6 ohm
DCR
0.2 ohm
Frequency response
1,700Hz~40,000Hz
Sensitivity
95dB/2.83V/1M
Power handling
14W Nominal, 40W Max
Weight
580gm/ 1.28lb
Price $81.00 each
Mounting information
Frequency Response
Warning! Testing Instructions
0.5W@0.5meter signal from 1,000Hz~40,000Hz - without capacitor, and must make sure amplifier is well connected with tweeter.
Turn off the amplifier before suspending the connection, and powering off amplifier is a must before connection.
Full Range Test is not recommended, because in the low frequency the impedance of tweeter is almost zero, which makes it very easy to burn the tweeter and overload the amplifier. Never do any test below 200Hz.
200 millivolt may be used to test frequency.